Panasonic DP-3530 - Page 651

651
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
11.1.7.2.4. Light-Emitting Diodes (LED) and Check Pins by PCB
This section discusses the LEDs and check pins used in the Machine that are needed in the field.
Caution:
The VRs and check pins not discussed in this section are for factory use only. Making adjustments and
checks using these will require special tools and instruments and adjustments must be to high accuracy.
Do not touch them in the field.
1. Finisher Controller PCB
Fig. 7-041
Table 7-019
Switch Function
SW1 Adjust the height sensor / alignment plate position / stapling position and move
the trays up, etc.
SW2 Adjust the alignment plate position / staple position and move the trays down, etc.
SW3 Adjust the height sensor / alignment plate position and stapling position, etc.
11
9
J17
1
1
J27
8
1
1
2
1
2
J11
10
J1
J19
1
111
111
11 1
18 1416
1
7
1
12
J12
SW1
J3
J2
J14
SW3
J9
J6
J16
SW2
LED1
LED2
14
J21
1
14
1
4
1
J25
1
51 115
15
J19
J7 J5
61
J10
CB1