376
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
(5) Connect the Sensor Cable to the Sensor
Connector found in the left bottom corner of each
Tray.
(6) Mount the Harness Covers to each Tray Unit.
Starting with the bottom Harness Cover
(Shorter).
Note:
Insert the bottom Hook into the top hole and snap
it into place.
6. Preparing the Host Machine for Installation
(1) Loosen the 2 Screws and remove the SPC
Cover.
(2) Remove the Toner Waste Container.
(Refer to Section 2.2.2. the Service Manual)
(3) Install the Finisher IPC PC Board onto SPC PC
Board, Connector CN727.
(4) Reinstall the SPC Cover and Toner Waste
Container.
Note:
Gently and securely insert the IPC PC Board as
illustrated.
Sensor Cable
Harness Cover
(1)
(3)
To Next Page
Loading...
