Panasonic DP-6030 - Page 799

799
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Fig. 3-091
2-4. Removing the Waste-Full Photo Sensor PCB
(1) Remove the Punch Controller PCB. (See 2-1.)
(2) Remove 2 Screws [1] to remove the PCB Film
[2].
Fig. 3-092
(3) Disconnect the Connector [3] to remove the
Waste-full Photosensor PCB [4].
Fig. 3-093
2-5. Removing the Waste Full LED PCB
(1) Remove 1 Screw [1].
(2) Disconnect the Connector [2] to remove the
Waste-full LED PCB [3].
[2]
[1]
[3]
[4]
[2]
[1]
[3]