Panasonic EH-SW50

28
English
3
3
Hold the water
supply plate up
and let the
excess water
runs off.
• Make sure the
water covers the
mesh holes
completely. If there
is too much water
and large water
drops form on the
water supply plate,
the water drops
may drip when the
appliance is
attached to the face.
(See the diagram
on the right)
Mesh holes
Diagram showing the water
supply plate from the side.
Water
•Do not use face lotion, etc.
•If the water supply plate is not wet, you will not
feel steam.
•Do not wet the main unit itself with tap water.
4
4
Attach the water
supply plate to the
main unit.
1. Hold so that the
protruding part of
the knob is facing
upward.
2. Set the water
supply plate under
the water supply
plate attachment
clasps (2 pc) on the
main unit.
3. Press down firmly
on the knob and
attach securely.
1
2
3
Protruding
part
Clasp
Snap
•The water supply plate has front and rear sides. It
cannot be properly attached if it is attached to the
wrong side.
•If there is a lot of water on the water supply plate,
water drops may splash when attached.
EH-SW50_CH.indb 28 2013/04/16 19:42:51