EN12
More than 5 cm
(When the backrest is fully down)
(When the backrest is fully up)
More than 30 cm
3
)
Note that the distance between the wall
and the backrest when placing
Check whether it hits the wall
Place the controller in
the controller pocket and
place the power cord on
the seat surface
❶
Preparation
❷
Movement
Castors can be used when moving the
unit.
Mat etc. Castor
Lift the unit to no higher than the lower back.
Setup
(continued)
Do not
hold here
Hold it by the hard part inside
①
After procedures EN13 to EN14
❶・❹
～❺
, then press
②
Press to raise the backrest
③
Press
④
Turn the power switch "
关
" and
remove the power plug.
To Next Page
Loading...
