EN29
"HEAT" / "SOLE HEAT"
Adjustment of massage heads
Press during massage.
Persons with sensitive skin are expected to wear thick socks before using these two functions.
When "HEAT" are used, do not let the massage
heads touch the same place for a long time.
Do not use the "SOLE HEAT" massage for long
time.
(Low temperature burns* may occur.)
*
Burns may occur at relatively low temperatures (40 °C
to 60 °C) when in contact with the same area of skin
for long periods of time, even if you do not feel heat or
pain.
Method to adjust distance
adjustment of the massage heads
Adjust through ▲ or ▼.
ㅡ
Each time after either button is
pressed, the massage head will
move for about 1.5 cm.
ㅡ
If either button is pressed and held,
the massage head will keep moving
till the button is released.
(For the "MANUAL" program and
the "AIR/STRETCH" massage only)
Adjust though
◀
or
▶
.
ㅡ
Distances of the
massage heads can be
adjusted to be larger or
smaller.
Applicable to massage modes including "Neck
roll", "Lower back roll", "Tap", and "Stretch”
only.
The light corresponding to rough position
of the massage head will flicker.
After is pressed, adjustment will be
done with the steps below.
Warming devices (heaters) of the massage
heads transfer heat to the massaged parts
through the heat contact fabrics.
In "SOLE HEAT" massage, the warming devices
(heaters) in the foot massage section will warm
your feet to make you warm and comfortable.
Only fabrics in the tiptoe positions are warm.
Make the tiptoes in close contact with the warm
transfer part. When the foot massage section is
being raised, the warm transfer part is in close
contact with the soles to make you feel warm.
You may cover
your knees with
a blanket to get
warmer.
Warming device (heater)
Rubber part of massage head
Warming device (heater)
●
When not in back massage, or "AIR/STRETCH", the
function cannot be used separately.
Display
Lights off
Heat
DOUBLE HEAT
HEAT SOLE HEAT
OFF
Up-down adjustment of a massage head
Set as you like
To Next Page
Loading...
