Panasonic EP-MAG3

EN18
Assembly
（Continued）
5
Turn on the power and raise the backrest to the upright position.
Insert the power plug into the
power outlet.
● Always be sure to insert into an AC
120 V plug.
Fasten the controller
cord using the clip.
● Fasten so the cable under
the clip will not sag too
much with the backrest
raised.
(Because there is a chance
of the cord becoming
tangled with your feet,
etc.)
Placing the controller
into the controller
stand.
Confirm the lock switch key
is set to the “open” position.
Confirm the power switch is
set to the “on” position.
Press
on the controller twice.
● Press once, and then press again approx. 1 second later.
Backrest will rise automatically.
●❶
●❷
●❶
●❶
●❷
●❷
●❶
●❸
●❷
●❸
●❹
6
Placing the controller