5 Unfasten the fasteners on the seat (3 locations)
in order of 1, 2, then 3, and pull out the
controller from the slit in the cover.
6 Remove the cover from the unit.
Fitting
Lounger cushion cover
1 Fold the cushion forwards and insert it into
the zipper opening.
When the cushion is fully
inserted, hold the top corners
of the cover and shake it up
and down a few times.
2 Close the zipper.
3 To ensure the cushion is equally distributed within the cover, pat the front and rear of the
cover a few times.
Front cover
1 Pull out the leg/foot massage section.
2 Pull over the side of the sole section.
How to neatly pull it over
1Aligntheseamlineononesiderst,andthenpull
over by pinching on the edge of the cover.
2 Pull over on other side in similar manner.
The side with tab is the
top side.
3 Pull down the tab, and fasten the tip of the tab
to the bottom section of the sole section using
the fastener.
Make sure that the cover
is fully covering the back
side too.
To Next Page
Loading...
