Unit cover
1 Put the cover on the unit.
2 Insert the controller and the cord
through the slit in the cover.
3 Fasten the zippers at the sides of the
backrest (2 locations).
4 Fasten the fasteners at the sides of the
seat (2 locations).
Tuck in the cover while pulling on it.
Armrest
5 Pull the controller pocket to the outside
of the armrest A, and lay the cover over
the armrest B.
6 Pull the cover over the top section of the
backrest.
7 Fasten the zippers (2 locations).
It will close cleanly by alternately closing little by little
while pulling on the cover at the side of the armrest.
8 Pull the power cord through the hole.
Align the seam line of the cover with the
top corners of the backrest.
To Next Page
Loading...
