English
10
Trimming with no attachments
Cutting without an attachment will trim hair length to 1 mm
or less.
1. Cut hair by placing the clipper head
directly on the scalp.
AC operation
If you connect the AC adaptor to the clipper in the same
way as for charging, and set to the switch to where “1” is
visible, you can use it even if the battery capacity is low.
RGE”, wait about 1 minute and then set it back to “1”.
the switch left in “1”. It causes the battery life to shorten.
Blade maintenance
Ca
re
The following is the symbol for a washable clipper.
The symbol means the hand-held part may be
cleaned under water.
Mounting and removal of the blade
1. Hold the clipper with the “Panasonic”
mark facing upward and push the blade
with your thumb while catching the
blade in your other hand.
Be sure to set the switch to “0•CHARGE”
before you remove the blade.
•
►
►
If the clipper does not operate, set the switch to “0•CHA-•
Be careful not to discharge the battery completely with •
2. To remount the blade, fit the
mounting hook into the blade
mounting on the clipper and
push in until it clicks.
Blade life
Blade life will vary according to the frequency and length
of use. It is expected to be about 2 years when using the
clipper twice a month for 2 0 minutes each time. If cutting
efficiency is reduced despite proper maintenance, change
the blades.
Battery life
Battery life will vary according to the frequency and length
of use. If the batteries are charged 3 times a month, the
service life will be approximately 3 years.
every 6 months even when not in regular use because
the charge will drain from the batteries and their service
life may be shortened.
►
►
It is recommended that the clipper be recharged at least•
ER-CA70_CH.indb 5 2009/01/14 11:23:42
To Next Page
Loading...
