Panasonic ER-CA70 User Manual

Thinning Attachment
1. Insert the attachment
over the trimming blades
until it clicks as
illustrated.
2. To remove the
attachment, push both
sides while pulling the
attachment.
Cutting your hair
Cut
1
Cut hair to the correct height by
moving the clipper back against the
flow of the hair.
Do not use the clipper in an inverted
position. This can cut hair too deeply.
•
►3/6mm, 9/12mm, 15/18mm comb attachments
3
mm
6
6mm
3mm
9mm
12mm
18mm
15mm
3/6mm
9/12mm
15/18mm
1. Select the
cutting heights
indicated on the
insides and
sides of the
attachments.
2. Mount the
attachment to
the clipper as
illustrated.
3. Remove the
attachment
from the clipper.
Natural cutting attachment and Point cutting
attachment
These attachments allow thinning of hair
by cutting from the inner side. Hair volume
is reduced, and hair tips are trimmed at
various lengths to leave a natural look.
Natural cutting attachment:
Desirable hair lengths are 30 mm-70 mm
(hair lengths shorter than 30 mm may be
too short to cut in some situations.)
Point cutting attachment:
Desirable hair lengths are less than 30 mm
(for cutting sideburns and around the ears.)
NATURAL
ATTACHMENT
POINT
ATTACHMENT
►
►
ER-CA70_CH.indb 4 2009/01/14 11:23:42
9
English

Panasonic ER-CA70 Specifications

General

Brand	Panasonic
Model	ER-CA70
Category	Hair Clipper
Language	English