7
English
How to use
• Clean the appliance after use.
1
2
as not to block the exhaust hole (a
3
Cut hairs using the tip of the outer blade (metallic part).
The outer blade surface may get a little warm during use,
but performance will not be affected.
Note
• The use time after a full charge is as follows.
ER‑CBL1: 80 minutes
ER‑CBN1: 60 minutes
(Based on dry using at 20 °C – 30 °C)
The operating time may differ depending on the frequency of
use and the operating method.
Even though the battery runs out, you can use for 5 minutes
after 3‑minute charge.
(This will differ depending on usage.)
Removing and mounting
• Make sure that the main body is turned off.
Remove
Remove the head while pushing the head release button (
b
Stand the head when it is removed.
Mount
1
Insert it slowly so as not to injure your nostril or ear canal.
2
Some trimmings may remain inside your nostril or ear canal
after cutting, so remove them using a tissue or similar.
1
2
You cannot trim the hair to length with this head.
It is not suitable for the hair below 0.5 mm.
To Next Page
Loading...
