8
English
Maintenance
• Make sure that the main body is turned off.
• After cleaning, be sure to store with the blades, the
trimmings box and the protective cap attached.
How to clean
With water
1. Apply some hand soap and some water to the outer blade.
2.
Turn on the power and turn off the power after 10 seconds. (Fig. 7‑
1
)
To remove light dirt
3. Open the water inlet and
turn on the power again.
If the trimmings box is
removed, open the water
inlet after attaching the
trimmings box.
4. Run water down the water
inlet (Fig. 7‑2), rinse well
and turn off.
3.
Remove the head,the blades
and the trimmings box.
4. Rinse them with running
water. (Fig. 7‑3)
• Cover the drainage outlet
of washbasin to prevent
the inner blade from
5. Wipe off the water with a dry cloth and dry it well.
It will dry faster with the blades and the trimmings box removed.
Notes
•
Note the following precautions to avoid malfunction and damage.
•
Do not use hot water or any detergents other than hand soap.
• Do not wipe with thinner, benzine, alcohol etc.
1. Remove the head, blades and the trimming box.
2. Brush off any hair trimmings from the head, blades and the
trimming box.
Be careful not to deform the inner blade.
How to open and close
the water inlet
Open
” mark aligns with the
” mark of the head to open the water inlet. (Fig. 9‑1)
Close
” mark aligns with the
” mark of head. (Fig. 9‑2)
Removing and mounting
the trimmings box
1)
” mark aligns with the
” mark of the head.
2)
1.
” mark
of the head.
c).
2. ” mark aligns with
” mark of the head.
To Next Page
Loading...
