Panasonic ER-FGP72 - How to Use

11
English
Charging without the charging stand
1. Connect the appliance plug to the appliance socket.
2. Plug in the adaptor into a household outlet.
AC operation
If you connect the AC adaptor to the appliance in the same way as
for charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly
or stop, even with the AC operation. In this case, charge the
battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.
How to use
• Check that the blades are not damaged or deformed before use.
• Turn the appliance off.
• Apply the lubrication oil to the blade before and after each use.
(See page 13.)
• The appliance may not operate in an ambient temperature lower
than approximately 0 °C.
1
Setthetrimmingheight.
2
Pressthepowerswitchtoturnontheappliance.
Setting the trimming height
For a trimming height of 0.8 to
2.0 mm, turn the dial to the desired
height.
Use an attachment for a trimming
height higher than 3 mm or more.
1.4
Trimming
height
indicator
0.8
1.1
1.4
1.7
2.0
Removing and mounting the comb attachments
►Mounting the attachment
1. Select the trimming heights indicated
on the insides and sides of the
attachments.
2. Set the dial to “0.8” and then mount
the attachment to the main body as
illustrated.
0.8
0.8
►Removing the attachment
Slide one side of the attachment off the
mounting in direction indicated with the
arrow.