Panasonic ER-GC71 - Cleaning with Brush; Blade Removal and Mounting

16
English
3. Wipe off the water with a towel
and let it dry naturally.
•It will dry faster with the blade
removed.
4. Apply the oil to the blade after
drying. (See page 17.)
5. Attach the blade and
attachment to the main body.
Cleaning with the brush
Main body and blade
• Remove the blade. (See this page.)
1. Brush off any hair trimmings
from the main body and from
around the blade.
2. Brush off the hairs from the
blade edge.
3. Brush any hair trimmings out
from between the stationary
blade and the moving blade
while pressing down the
cleaning lever (
a
) to raise the
moving blade.
a
4. Apply the oil to the blade. (See page 17.)
5. Attach the blade and attachment to the main body.
Removing and mounting the blade
Removing the blade
Hold the clipper with the switch
facing upward and push the
blade with your thumb while
catching the blade in your other
hand.
Mounting the blade
Fit the mounting hook (
B
) into the blade mounting (
A
)
on the clipper and then push in until you hear a click.
B
A
PB017706 - ER-GC63 53������_(01GB)_04-25-19.indd 16 2019/4/25 15:04:16