Panasonic ER-GC71 - Operational Issues and Charging Problems; Removing the Built-in Rechargeable Battery

18
English
Problem Action
Clipper stopped
functioning.
Operating time
is short.
Charge the clipper.
Or use with the AC operation.
(See pages 11 and 12.)
Charge the battery for
approximately 16 hours
continuously to rejuvenate it.
If few uses remain even after
charging, the battery has
reached the end of its life.
(Fluid may be leaking due to
degradation at the end of
battery life.)
Contact an authorized service
centre for repair.
The clipper cannot
be charged.
Push the appliance plug into
the main body all the way and
make sure the charge indicator
lamp ( ) glows.
Charge within the
recommended charging
temperature of 0 °C to 35 °C.
Clipper can be
used for only about
10 minutes even
after charging.
Have the battery replaced by
an authorized service centre.
Blade life
Blade life varies according to the frequency and period
of use of the clipper.
For example, the blade life is approximately 2 years
when using the clipper for 20 minutes twice a month.
Replacethebladesifcuttingefficiencyreduces
substantially despite proper maintenance.
Battery life
Battery life will vary according to the frequency and
length of use. If the battery is charged once a month,
the service life will be approximately 3 years.
Iftheoperatingtimeissignificantlyshorterevenaftera
full charge, the battery has reached the end of its life.
Removing the built-in rechargeable
battery
Remove the built-in rechargeable battery before
disposing of the clipper.
The battery is to be disposed of safely.
Please make sure that the battery is disposed of at an
officiallydesignatedlocationifthereisone.
PB017706 - ER-GC63 53������_(01GB)_04-25-19.indd 18 2019/4/25 15:04:17