Maintenance
Cleaning
Clean the main body and the blade after each use.(If not cleaned, the motion will become poor and the
sharpness will worsen.)
Do not use thinner, benzine, alcohol, or other chemicals. Doing so may cause failure, cracking, or discoloration
of the main body. Wipe the main body only with a soft cloth slightly dampened with tap water or soapy tap
water.
Make sure that the main body is turned off.
Remove the main body from the AC adaptor.
With water
To remove light dirt
1. Remove the attachment and turn the main body on.
2. Run water down the water inlet at the back of the main body, rinse thoroughly for approximately 20 seconds,
and then turn the main body off.
To remove heavy dirt
1. Remove the attachment and blade.(See pages 13 and 16.)
To Next Page
Loading...
