Notes:
Stretch the skin on the areas with loose or flabby skin, or with wrinkles, and lightly apply the edge of the blade
or attachment.
Do not use the attachment on wet hair. Wet hair might clump or stick to the skin, becoming hard to trim. If you
use the attachment to trim wet hair, you may not be able to achieve a uniform trim.
For areas with thick or dense hair growth, trim a bit at a time. Hair sometimes gets caught or builds up in the
attachment. When this happens, clean the attachment.
How to use
Apply the oil to the blade before and after each use.
The appliance may not operate in an ambient temperature lower than approximately 0 °C (32 °F).
• Please clean the appliance after each use.
Note before trimming
• Make sure that the main body is turned off.
• Check that the blades are not damaged or deformed before use.
Trimming dry hair
1. Select the desired attachments, then press the power switch to turn on the power and trim.
Use the appropriate attachment as needed. It can also be used without the attachment.
Without the attachment (See page 14.)
Skinguard attachment (See page 14.)
Trimming height comb attachment
2. Turn off the switch after use.
Trimming wet hair
1. Do not use the attachment when trimming wet hair. 1 Wet and apply soap to your body.
2. Press the power switch to turn on the power and trim.
Without the attachment.
3. Apply less pressure than you would when trimming dry hair, and move the main body in a gliding motion.
4. Turn off the switch after use.
Removing and mounting the attachments
Take care not to injure hands, etc., with the blade when removing or mounting the attachment.
Removing the attachment
Hold the main body securely and pull the attachment out upward and remove it from the main body.
Hold the rib ( a ) part securely and remove the skinguard attachment.
To Next Page
Loading...
