Panasonic ER-GP23 - Charging and Operation; Charging with Stand; Charging without Stand; AC Operation

10
English
Charging(Fig.2)
1
Connecttheapplianceplugtothestandsocket.
2
Placetheapplianceonthechargingstand.
3
Inserttheadaptorintoahouseholdoutlet.
• Check that the charge status lamp glows.
• Charging is completed after approx. 1 hour.
► Displaywhilecharging
While
charging
(Low battery
capacity)
While
charging
After charging
is completed
5 seconds
later after
charging is
completed
( :Glows, :Blinks, :Turns o󰀨)
4
Disconnecttheadaptorafterchargingiscompleted.
<Howtocheckthatchargingiscompleted>
Insert the main body again after removing it from the charging
stand. If the lamps glow and then turns o󰀨 after 5 seconds,
charging is completed.
► Notes
• Recommended ambient temperature for charging is
10 °C – 35 °C. It may take longer to charge, or the charge
status lamp will blink quickly and the battery may fail to
charge properly in extremely high or low temperatures.
• 1 full charge will provide approximately 100 minutes of
continuous operation. (Based on dry using at 20 °C – 30 °C)
The operating time may di󰀨er depending on the frequency of
use and the operating method.
• When charging the appliance for the rst time or when it has
not been in use for more than 6 months, the charging time
may change or the charge status lamp may not glow for a
few minutes. It will eventually glow if kept connected.
• If there is noise from the radio or other sources while using
or charging the appliance, move to a di󰀨erent location to use
the appliance.
• The battery will deteriorate if not used for over 6 months, so
make sure to perform a full charge at least once every 6 months.
Chargingwithoutthechargingstand(Fig.3)
Plug the AC adaptor into the main body and the household outlet.
AC operation
If you connect the AC adaptor to the appliance in the same
way as for charging, and turn on the power, you can use it.
• The charge status lamp glows when using the AC operation.
• If the remaining battery is too low, the blades may move
slowly or stop, even with the AC operation. In this case,
charge the battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.