Remove the built-in rechargeable battery before disposing
the appliance�
This gure must only be used when disposing the appliance, and
must not be used to repair it. If you dismantle the clipper yourself,
it will no longer be waterproof, which may cause it to malfunction.
• Remove the appliance from the AC adaptor.
• Press the power switch to turn on the power and then keep the
power on until the battery is completely discharged.
• Perform steps 1 to = and lift the battery, and then remove it.
• Take care not to short circuit the positive and negative terminals
of the removed battery, and insulate the terminals by applying
tape to them.
Specications
Power source
See the name plate on the AC adaptor.
(Automatic voltage conversion)
Motor voltage
3.6 V
Charging time Approx. 1 hour
This product is intended for household use only.
ER-SC40_CAN.indb 17 2017/07/18 17:46:29
To Next Page
Loading...
