Panasonic ER-SP20 - Maintenance

10
English
Maintenance
• Make sure that the main body is turned off.
• Remove the AC adaptor from the main body.
• Lubricate after cleaning and store the main body with the
protective cap attached.
How to clean
With water
1
Applysomehandsoapandsome
watertothesystemouterfoil.
2
Press for more than 2 seconds
to activate the sonic vibration
cleaningmode.
• Splashing of foam is suppressed.
• The battery capacity lamps blink in
order.
• After about 20 seconds, it will be
automatically turned off, or you can
turn it off by pressing the power
switch.
3
Removetheouterfoilsection.(Seepage11.)
4
Rinsethemwithrunningwater.
• Splashing is reduced by rinsing the
appliance in sonic vibration cleaning
mode.
5
Shake up and down several times to remove the
water.
• Be careful not to hit the appliance on the sink or any
other object while draining the water.
6
Wipeoffthewaterwithadry
clothanddryitwell.
• Leave the main body to dry whilst
avoiding direct sunlight.
• Do not dry the appliance with a
dryer or a fan heater.
Notes
•
Do not use thinner, benzine, alcohol* or other chemicals. Doing
so may cause failure, cracking or discoloration of the parts.
*Parts other than blades
• Do not use any kitchen or bathroom detergents other than
hand soap. Doing so may cause malfunction.
With the brush
Remove the outer foil section and the inner blades.
(See page 11.)
►Cleaning with the long brush
Clean the outer foil section,
system outer foil, and the main
body using the long brush.
►Cleaning with the short brush
• Clean the inner blades using the short
brush by moving it in direction as
illustrated.
• Do not move the short brush
perpendicularly against the blades as it
will damage the inner blades and affect their sharpness.