Panasonic ES-EY30A-V503

21
GBDFINLEDKPNSFINPLCZSKHROTR
Problem Possible cause Action
Cannot
remove hair.
When
epilating
The appliance is used
on long hair.
Use on hair
approximately 2 to 3 mm
long.
The epilation head
surface is not in close
enough contact with
the skin.
The appliance is not
moved against the
owofhair.
Make the epilation head
in closer contact with the
skin and move.
Move the appliance
againsttheowofhair.
(Refertopage16.)
The hair
becomes
stubble.
The appliance is
moved too fast.
Move it slowly.
(Approximately
3~5 cm/sec)
(Refertopage16.)
The appliance
is not
removing the
hair as well as
before.
Hair dust has
accumulated.
Clean the hair dust.
The skin protector or
discs are deformed,
cracked, or damaged.
Requestrepairatan
authorized service
centre.
Sensitive area
cap comes off
during
operation.
The appliance is
being pressed too
hard against the skin.
Contact the skin with
gentle force.
The appliance is not
applied at a 90° angle
to your skin.
Apply at a 90° angle to
your skin.
(Refertopage16.)
The appliance
is not cutting
as well as
before.
When
shaving
Hair dust has
accumulated.
Clean the hair dust.
The blade is
deformed.
Replacetheblade.
Guidelines for
replacement:
Outer foil:
Approximately 1 year
Inner blade:
Approximately 2 years
The blade is worn out.
Cannotle.
When
caring for
feet
Theleiswornout.
Replacethele.
Guidelines for
replacement:
Approximately 1 year
The appliance is used
in the SOFT mode.
TryusingitinPOWER
mode.
Cannot get rid
of odor.
It is dirty.
Soaktheleinwaterfor
approximately 24 hours
before washing.