Panasonic ES-LT6A

36
English
Cleaning the shaver
Do not use kitchen, bathroom, or toilet detergents. Also,
do not wipe with thinners, benzine, alcohol etc.
Doing so may result in malfunction.
1. Turn the power switch OFF, and disconnect the AC
adaptor.
• Unlock the switch lock.
2. Apply some hand soap and some water to the
system outer foil.
3. Press the power switch for
more than 2 seconds to
activate the sonic vibration
cleaning mode.
• The battery capacity lamps
blink in order.
ES‑LT6A
• The battery capacity lamp
(
) and the charge status lamp ( ) blink
alternately.
ES‑LT2A
• After about 20 seconds, it will be automatically
turned off.
4. Remove the outer foil section and
press the power switch for more
than 2 seconds to activate the
sonic vibration cleaning mode.
5. Clean the shaver, the outer foil
section, and the trimmer with
running water.
ES-LT6A ES-LT2A
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture.
Hitting the vanity, etc., while shaking the shaver may
cause malfunction.
• Splashing is reduced by rinsing the shaver in sonic
vibration cleaning mode.
6. Wipe off any drops of water with a dry cloth.
7.
Dry the outer foil section, the
shaver, and the trimmer completely.
8. Attach the outer foil section to the shaver.
9. Lubricate the shaver.
The mark on the left means suitable for
cleaning under an open water tap.
Warning
Disconnect the cord from the shaver before
cleaning it in water to prevent electric shock.
ES-LT6A_2A_CH.indb 36 2016/01/27 15:42:31