20
►Removing the outer foil section
Press the foil frame release buttons [A5] and
lift the outer foil section [A9] upwards.
►Attaching the outer foil section
After turning the foil frame mark ( ) to the
front, securely attach the outer foil section [A9]
to the shaver until it clicks.
►Replacing the system outer foil
1. Press the system outer foil release buttons
[A:] and pull down the system outer foil
[A2].
2. Align the foil frame mark (
) and the
system outer foil mark (
) and securely
attach together until it clicks.
• Do not press the system outer foil release buttons with
excessive force.
Doing so may bend the system outer foil, preventing
complete attachment to the foil frame.
►Replacing the inner blades
1. Remove the inner blades [A;] one at a time.
2. Insert the inner blades one at a time.
Note
Do not throw away the foil frame.
Replacing the cleaning liquid
If the STATUS lamp glows for 5 seconds when the SELECT
button is pressed, the cleaning liquid needs to be replaced.
• Even if the STATUS lamp does not light up, replace the
cleaning liquid after 6 months have passed.
1
Remove the AC adaptor [C] and
remove the cleaning liquid unit
[B]. (See page 14.)
2
Wash away the old cleaning
liquid.
• It can be drained as sewage.
1
3
Rinse the cleaning liquid unit.
• Pour water as illustrated while tilting the
cleaning liquid unit and shaking it gently.
• You can clean with the cleaning liquid filter
removed.
After washing, be sure to attach the
cleaning liquid filter.
4
Gently wipe off any beard
trimmings attached to the inside
of the cleaning tray (a) with a
cloth or tissue paper dampened
with water.
• Clean the corners and uneven parts
of the cleaning tray with a cotton
swab dampened with water.
5
Prepare the new cleaning liquid.
(See page 14.)
ES-LV9N_EU.indb 20 2015/12/11 13:05:58
To Next Page
Loading...
