24
Problem Action
Cleaning liquid leaked
from the cleaning liquid
unit.
Do not press the cleaning liquid
unit removal button during any
mode.
Place the self‑cleaning
recharger horizontally.
If you use the self‑cleaning
recharger when the shaver is
wet or when soap or shaving
gel is on the shaver, cleaning
liquid may leak.
The cleaning liquid unit
cannot be removed.
Place the self‑cleaning
recharger on a hard, flat surface.
(See page 14.)
The mode does not start.
Check that the AC adaptor is
connected to the self‑cleaning
recharger, and that the adaptor
is plugged in to a household
outlet. (See page 17.)
Confirm that the shaver is
properly attached to the self‑
cleaning recharger.
(See page 17.)
The Clean or Dry function may
not operate under extreme low
temperatures (approximately
0 °C or lower).
Check if the STATUS lamp is
glowing. (See page 21.)
Problem Action
The shaver cannot be
charged.
Gently wipe the main body rear
terminals and the charging
terminals of the self‑cleaning
recharger with a cloth or tissue
dampened with water.
Makes a loud sound.
During cleaning:
The self‑cleaning recharger
makes a loud sound due to
the
cleaning of the blades.
After cleaning:
The self‑cleaning recharger
makes a loud sound due to
the removal of water droplets
in order to speed drying.
The sound after cleaning is
different from the sound during
cleaning. The water level has
dropped and it is removing
water droplets from the blades
after cleaning. This does not
indicate a problem.
►Shaver
Problem Action
The power switch does
not turn ON.
Unlock the switch lock.
(See page 16.)
The clean lamp (
)
glows.
(It turns off in about
1 minute.)
Please clean the blades with the
self‑cleaning recharger or the
sonic vibration cleaning mode.
ES-LV9N_EU.indb 24 2015/12/11 13:05:58
To Next Page
Loading...
