4
English
Clean
Cleaning the shaver
1. Remove the shaver from the AC adaptor.
2. Apply some hand soap and some water
to the outer foil.
3. Turn the shaver on.
4. Turn the shaver off after 10-20 seconds.
5. Remove the outer foil section and turn the
shaver on.
6. Clean the shaver and the outer foil
section with running water.
7. Wipe off any drops of water with a dry
cloth.
8. Dry the outer foil section and the shaver
completely.
9. Attach the outer foil section to the shaver.
Shave
Using the shaver
1
1
Slide the power
switch upwards.
2
2
Hold the shaver as
illustrated above and
shave.
Adequate ambient temperature for using is 0-40 °C. If you use
the appliance in temperature outside of the recommended range,
it may stop functioning.
Start out shaving by applying gentle pressure to your face.
Stretch your skin with your free hand and move the shaver back
and forth in the direction of your beard. You may gently increase
the amount of pressure as your skin becomes accustomed to
this shaver. Applying excessive pressure does not provide a
closer shave.
•
ES-RC30_TW.indb 4 2014/03/05 14:04:36
To Next Page
Loading...
