To Next PageTo Next PageWhy is the SYS or DIA high on my Panasonic Blood Pressure Monitor?
If the SYS or DIA readings on your Panasonic Blood Pressure Monitor are high, it could be due to several reasons. First, ensure the pressure cuff is positioned correctly, higher on your wrist. Second, make sure the pressure cuff is wrapped properly around your wrist. Lastly, remain still and avoid talking during the measurement to ensure accurate readings.
Why is the SYS or DIA low on my Panasonic EW-BW30?
If the SYS or DIA readings on your Panasonic Blood Pressure Monitor are low, it may be because the pressure cuff is positioned too high. Try positioning the pressure cuff lower. Also, ensure that you remain still and quiet while the measurement is being taken.
What to do if the indication disappears in the middle of the operation of my Panasonic EW-BW30 Blood Pressure Monitor?
If the indication on your Panasonic Blood Pressure Monitor disappears in the middle of operation, it is likely that the batteries are exhausted. You should replace the batteries.
What does it mean when the mark flashes on my Panasonic Blood Pressure Monitor?
If the mark flashes when readings are being taken on your Panasonic Blood Pressure Monitor, it could be due to a significant fluctuation in your pulse. In this case, take the reading again. Another reason could be that your hand or wrist moved during the measurement. Make sure to keep your hand or wrist still.
Why does the mark flash on my Panasonic EW-BW30 even though I did not move my hand or wrist?
If the mark flashes on your Panasonic Blood Pressure Monitor even though you did not move your hand or wrist, it may be because you tensed the muscles in your hand. Try to relax the muscles in your hand and then take the reading again.
General| Measurement Method | Oscillometric |
|---|---|
| Display | LCD |
| Measurement Range - Pressure | 0 to 299 mmHg |
| Accuracy - Pressure | ±3 mmHg |
| Power Source | 4 x AA Batteries |
| Measurement Range - Pulse | 40 to 180 beats per minute |
| Accuracy - Pulse | ±5% |
| Cuff Size | 22-32 cm |
Explains how to reset or clear the previously set height calibration for the sensor.
Explains how the device displays previous measurements as a graph to show trends.
