Periodontal pockets and the boundary between
the teeth and gums
■ Use the extra-fine brush to
brush these areas.
■ Place the brush head at a
45° angle.
■ Apply the ends of bristles
lightly against the teeth and
move the toothbrush slowly.
Front surface and the biting surface of teeth
■ Apply the brush head at a
90° angle.
90°
pWl
For the back of the front teeth or misaligned teeth
■ Place the brush head
vertically.
■ Move toothbrush to match
the angle of the teeth.
%
After use
Cleaning the brush head and the main unit
1 Remove the brush head.
• Remove the brush head straight
from the toothbrush shaft.
2 Wash the brush head under
running water.
Thoroughly rinse the inner and
bottom of brush head.
• Do not forcefully pull or force
apart the bristles on the brush
head. (Doing so may cause the
bristles to fall off.)
• Do not wash with water over
80 °C.
(Doing so may damage the
brush head.)
3 Wash the main unit under
running water.
• Do not damage or rub the
waterproof rubber seal (® ) with
hard materials.
• Do not immerse the main unit in
water long time.
(Otherwise, the water may seep
into the main unit.)
• Do not wash with water over
40 °C.
(Doing so may damage the main
unit.)
®
15
PB019965 - EW-DC12nnnnnn_(01GB)_02-19-21.indd 15 2021/2/19 15:30:48
English
To Next Page
Loading...
