Why do Panasonic Blood Pressure Monitor readings vary so much?
Blood pressure can fluctuate due to slight changes in your mental state, such as when a doctor takes a measurement. To check the accuracy of your Panasonic Blood Pressure Monitor, bring it to your doctor’s office and directly compare its readings with those taken by your physician. Also, relax for at least 5 minutes before taking another measurement.
What to do if the Panasonic Blood Pressure Monitor shows an “E”?
If the “E” is blinking on your Panasonic Blood Pressure Monitor, it could be due to several reasons. First, check that measurements are being taken correctly and that you are in the correct posture, ensuring the cuff is properly attached to your upper arm. Also, ensure the pressure cuff is correctly attached to your upper arm and the tube is fully inserted into its socket. This error can occur if pressurization exceeds 300 mmHg or if pressure decreases suddenly, or if the measurement process was performed until 20 mmHg was reached.
Why do measured values differ significantly on my Panasonic EW3111 Blood Pressure Monitor?
Inconsistent posture during measurements or insufficient time between readings can cause variations in measured values on your Panasonic Blood Pressure Monitor. Always wait about 5 minutes before taking another reading, and make sure you are relaxed.
Why is systolic pressure value high on Panasonic Blood Pressure Monitor?
High systolic or diastolic pressure values on your Panasonic Blood Pressure Monitor might occur if the cuff was held too low, i.e. not at heart level.
Why is systolic pressure value low on Panasonic Blood Pressure Monitor?
Low systolic or diastolic pressure values on your Panasonic Blood Pressure Monitor might occur if the cuff was held too high, i.e. not at heart level.
How to connect the tube to the cuff socket.
How to attach the cuff holder to the unit.
How to operate the device to take a reading.
Explanation of error code 'E' and how to resolve it.
Guidance for taking blood pressure readings while seated.
Guidance for taking blood pressure readings while lying down.
How to delete all stored readings from the memory.
General| Type | Upper Arm Blood Pressure Monitor |
|---|---|
| Measurement Method | Oscillometric |
| Display | LCD |
| Cuff Size | 22-32 cm |
| Accuracy (Pressure) | ±3 mmHg |
| Power Source | 4 x AA batteries |
| Technology | Intellisense |
| Measurement Range (Pulse) | 40-180 bpm |
| Accuracy (Pulse) | ±5% |
To Next Page