Panasonic EY6220 - Page 3

MODEL EY6220
DISASSEMBLY/ASSEMBLY INSTRUCTIONS
Before disassembly, remove the battery pack from the main unit
(Housing/Grip Handle Disassembly)
1 Remove the four housing screws and one grip fastening screw
(Fig 1)
2 Remove the decorative washer and fastening nut to separate grip
handle from housings A and B (Fig 2)
Note The steel balls (four pieces for both sides of hinge) may
fall out during disassembly and could be lost
Handle accordingly
(Fig 3)
* ♦ ♦
1
tuth
-—--
i -^ rr ~ > -
(Fig 1)
3 S e parate housings A and B, and take out clutch, gear-box, motor,
and switch
(Housing/Grip handle Assembly)
1 When reassembling, connect the black wire to 0 terminal and red
one to 0 terminal of the grip handle Also be sure to pinch the
wires into small ribs.
Note. Do not twist or cross the wires to avoid pinching of wires.
Note. Once remove the wires from terminals, the contact may be¬
come loose Reform the metal contact parts at the end of
wires with pinchers. These contactors pivot on the terminals
after snapped in place
(Fig 4)
(Fig 4)
2. Set the wire protection sleave at the base of housings A and B,
then couple grip handle to housings.
Note: Be sure to insert hinge cover into grip handle as shown.
(Fig 5)
(Fig. 5)