Panasonic F10 MARK II - Page 13

When the background is bright and the object appears-to be
too dark, adjust this knob to open the lens iris opening.
At the centre detent position, the auto iris is operated in
standard condition.
Note: (1) Whenever the iris is manually adjusted, this
knob should be reset to the centre detent
position after the camera is used under
unusual lighting conditions.
(2) When the camera is aimed at the scene which
contains excessively bright object such as the
sun or lamp, blue vertical bar may appear in
the picture. This is peculiar phenomenon of
CCD and it is normal. The camera should be
operated avoiding such scene.
10.
11.
12.
Lens Connector (20P) (LENS)
This connects the auto iris power servo control zoom lens
which automatically adjusts the incoming light intensity by
changing the !ens iris.
14P output signal selector (COMP-Y/C)
Either a composite video signal for 3/4’° VTR or a Y/C
video signal for 1/2'’ VTR is fed from 14P connector by
selecting the position of this switch.
Standby Switch (STANDBY/ON)
This switch is used for longer battery operation and selects
the conditions of the camera and the Panasonic portable
VTR as;
ON: The camera and the portable VTR are
operated normally. The red LED turns on.
The cylinder motor of the portable VTR is
OFF with the tape threaded and the camera
functions are also OFF, except Sync and
Microprocessor.
The unit is in operating condition after
necessary adjustments.
When the camera and portable VTR are not
used for 5-15 minutes, set the switch to the
STANDBY position.
Note : 1, When the camera is operated with some
of other manufacture’s VTR, the VTR
may operate incorrectly in the standby
mode of the camera.
2. The white balance set previously is
memorized even if the standby switch is
set to the STANDBY position.
STANDBY :