5-21
Troubleshooting
(2) Contents
Code Item Function Initial setting
UP00 Paper size (0) Letter R/A4R (1) Legal/B4 Copier: 3
or • Sets the paper size of each (2) Letter/A4 (3) Ledger/A3 System console:
c00 paper drawer. (4) Invoice/A5 Consult service
technician
UP01 Paper size priority (0) Letter/A4 (1) Letter R/A4R 0
• Specifies the paper size of most (2) Legal/B4 (3) Ledger/A3
frequent usage. (4) Invoice/A5
UP02 Margin value default (0) 5 mm (1) 10 mm 1
• Selects the margin shift value. (2) 15 mm (3) 20 mm
UP03 Edge value default (0) 5 mm (1) 10 mm 0
• Selects the edge width. (2) 15 mm (3) 20 mm
UP04 Book value default (0) 15 mm (1) 20 mm 1
• Selects the book void width. (2) 25 mm (3) 30 mm
UP05 Margin reduction ratio (0) Non (100%) (1) 95% 0
• Selects the reduction ratio in (2) 93% (3) 91%
margin mode.
UP06 Sorter mode default (0) Nonsort (1) Sort 0
• Determines the most frequent (2) Staple sort (3) Group
usage mode.
UP07 Duplex mode default (0) No (1) 1 ➞ 2 0
• Determines the most frequent (2) 2 ➞ 2 (3) Book ➞ 2
usage mode.
UP08 2 in 1 copy ratio (0) Full size (1) Reduction 1
• Selects whether to copy full size
or reduction in the 2 in 1 mode.
UP09 Auto edge default (0) OFF (1) ON 1
• Selects whether or not to disable
Auto Edge Deletion*
UP10 Skyshot mode default (0) OFF (1) M1, ON 0
• Enables or disables the use of (2) M2, ON (3) M1, M2 ON
skyshot mode.
UP11 Manual add toner (0) OFF (1) ON
• Allows the addition of toner as Toner is rapidly added after entering
determined by the operator. the number (1) and pressing Print key.
UP12 (Reserved)
to 18
UP19 Set key operator code
• Input key operator ID number.
* Auto Edge Deletion
To copy from the platen with the original cover or i-ADF open. Normally, this makes
a copy with a solid (black) area around the original if the original is smaller than the
copy paper. This mode eliminates the solid area automatically.
• Skyshot mode (UP10 or c10) disables the use of the other job run memory.
To Next Page
Loading...
