5-22
@
FP-7728 / 7735
FP-7718 / 7722
Press User
Preset key.
1·4
Input the desired
paper size
3
Select the desired
paper drawer/tray*
2
Example: Changing Paper Size
Perform following steps as shown below after any locking screws have been removed.
Example: Changing Check Size
To change preset check sizes, perform following steps.
1 Press user preset key.
2 Enter “1” and “0”, using multi-copy keys on the control panel, then press print key
to select UP10 (7728/35)/c10 (7718/22).
3 Enter “3”, using multi-copy keys on the control panel and press print key to select
M1 and M2 ON.
4 Enter “1” and “9” using multi-copy keys on the control panel, then press print key
to select UP19 (7728/35)/c19 (7718/22).
5 Enter key operator I.D. Code. (3 digit)
6 Enter “3” and “2”, using multi-copy keys on the control panel, then press print key
to select UP32 (7728/35)/c32 (7718/22).
7 Input the size of check in “Y” (paper width) direction, using UP/DOWN keys on
the control panel, then press print key to store.
Copy direction
Check
X
Y
8 Input the size of check in “X” (paper length) direction, using UP/DOWN keys on
the control panel, then press print key to store.
9 Enter “3” and “3”, using multi-copy keys on the control panel, then press print key
to select UP33 (7728/35)/c33 (7718/22).
AT Repeat the procedure 7 and 8.
AK Press user preset key to return to normal operating condition.
To Next Page
Loading...
