Panasonic FP-7830 - Page 62

4-22
3) Replacement of the thermistor
4) Replacement of the separation finger (upper/lower)
• Conduct procedure 5.
(3)(4) Remove the screw.
(5)Remove the thermistor.
• Replace the thermistor.
9
(1)Open the fuser exit cover.
(2)Remove the screws (x 2).
(3)Remove the separation finger (upper)
bracket.
10
(1) Remove the separation finger (upper)
spring.
(2) Remove the separation finger (upper).
• Replace the fingers (x 5).
11
(1)Remove the screw (x1) and fuser exit
cover pin then remove the exit cover.
(2)Remove the screws (x 2).
(3)Remove the duplex guide roller block and
bracket together.
12
SV507
5
4
3
3
2
2
1
1
2
2
1
2
2