Preventive
Maintenance
4-23
SV506
13
(1)Remove the spring (x 2).
(2)Turn the separation fingers and remove
them (x 5).
5) Replacement of the pressure roller/roller bearing
• Remove the heat roller (refer to step 5 to
7).
• Remove the separation finger upper/lower
brackets (refer to 10 and 12).
Mark the current height adjustment to
use as a reference during re-assembly.
(1)Remove the screws (x 2).
(2)Remove the entry guide.
(3)Remove the pressure roller.
• Remove the roller bearing.
14
2
2
1
1
3
1
2
1
To Next Page
Loading...
