Panasonic FV-08VSL3 - Lamp Replacement

10
1. Remove grille by pulling down the mounting
spring in the right side of “Panasonic” logo.
(Fig.16)
3. Remove the screw as shown in step 1 of Fig.18.
Remove the light cover as shown in step 2 of
Fig.18.
6. Reinstall the light cover.(Fig.20)
WARNING
Disconnect power source before working on
unit.
This is a pin type lamp base and the lamp’s
glass is fragile. To remove, pull out carefully.
4W night lamp has threade d base. Remove by
turning counterclockwise.
Make sure the temperature of lens and
lighting unit has cooled down before
maintenance(cleaning) or replacement
of lamp.
Remove dust and dirt from light cover
and lens, before replace the lamps.
CAUTION
Fig.17
Fig.18
Fig.19
Fig.19.
5. Replace the
(Fig.19 )
Install the
4W night lamp (Max 4W incandescent
lamp).
fluorescent lamps (Maxlite MLS13GU35
13W) as shown in step 2 and step 3 of Fig. 6
(page 7).
Fig.20
Lens
Lighting unit
Mounting
spring
2.Remove plug connector then pull down
the other mounting spring.
(Squeeze mounting spring and pull down
carefully.) (Fig.17)
4
Fig.16