Panasonic FV-11VHL1 - For New Type Lighting Unit Assy. (Electronic Ballast); For Old Type Lighting Unit Assy. (Magnetic Ballast)

INSTALLATION
II
(IN
EXISTING
CONSTRUCTION)
Installing
the
ventilating
fan
in
an
existing
building
requires
an
accessible
area
(attic
or
crawl
space)
above
the
planned
installation location, or existing ducting and wiring.
1. To install the ventilating fan, follow the procedures describe
installation.
Installation 1. Take the following precautions before
CAUTION
Check area above planned installation location to be sure th:
1. Duct work can be installed and that area is sufficient for proper ventilation.
2. Wiring can be run to planned location.
3. Nowiring or other obstructions wil interfere with installation.
2. _ Inspect duct work and wiring before proceeding with installation.
Plan suitable location for ventilating fan. (next to ceiling joist)
4,
Before
installation,
provide
inspection
and
maintenance
access
а!
a
location
that
wil
not
interfere
with
installation
work
shown in Installation |.
MAINTENANCE
+ Illustrations in this manual are for FV-11VHL1.
WARNING
Disconnect power source before working on unit. Routine maintenance must be done every year.
CAUTION
1. Never use petrol, benzene, thinner or any other such chemicals for cleaning the ventilating fan.
2. Donotallow water to enter motor.
3. Donotimmerse resin parts in water over 60 °C (140 °F).
1. Remove grille. (Squeeze mounting spring and pulldown.) 2. Wash and clean grille. (Use non-abrasive kitchen de-
(Fig.
8)
tergent.)
Wipe
dry
with
new
cloth.
(Fig.
9)
Fig. 9