Panasonic FZ-10 - Inserting and Closing the CD Lid; Storage Manager Usage; Saving Game Data; Removing Saved Game Data

FZ-10
I
2-2.
Disassembly
/
Reassembly
Note:
Before
disassembling,
be
sure
to
perform
the
following
procedures
first.
1.
Remove
the
CD-ROM
disk if it
is
inserted
in
the
CD-ROM
drive.
2.
Turn
the
power
switch
off.
3.
Disconnect
the
AC
power
cord.
4.
Remove
the
optional
units.
Caution:
Please
follow
directions
carefully.
Do
not interchange
screws
in
any
part of
the
system.
•
Reassemble
in
the
reverse
order
Top
Case
Figure
1
Traverse
Unit
Pin
<B>
Pin<B>
Figure
2
Insulator
Figure
3
(1)
Turn
this
unit
(FZ-10)
upside
down
and
place
it.
(2)
Remove
seven
screws
<A>
as
shown
in
figure
1.
(3)
Turn
it
over
again
and
gradually
raise
the
top
case.
(1)
After
removing
the
top
case,
remove
the
two
pins
<B>
as
shown
in
figure
2.
(Push
from
the
bottom
side.)
(2)
Remove
the
traverse
cover.
(3)
Gradually
raise
the
traverse
unit
and
then
disconnec_t
the
five
connectors
as
shown
in
figure
3.
(4)
Remove
the
traverse
unit.
2-2