Panasonic FZ-10

FZ-10
WARNING
■ PRECAUTION OF LASER DIODE
CAUTION: This unit utilizes a laser.
Invisible laser radiation is emitted from the optical pickup lens when the unit is turned on:
1. Do not look directly into the pickup lens.
2. Do not use optical instruments to look at the pickup lens.
3. Do not adjust the preset variable resistor on the optical pickup.
4. Do not disassemble the optical pickup unit.
5. If the optical pickup is replaced, use the manufactures specified replacement pickup only.
6. Use of control or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
om □ omo DODOO DODOO DDDDll
D
0 0
0
0
0
0
■ SAFETY PRECAUTION
CLASS 1 LASER PRODUCT
LASER KLASSE 1
1. Before servicing, unplug the power cord to prevent an electric shock.
YARNING
06YII.IO~NAA
~~FAR.IO . .
ATTENTION
RAYONEMEHT LABER IIMUllE
EH CM O'OU\IERT\IE. EXPOSmON
DANClEAEIJSE All FAISCEAU.
VORSICHT
UNSICHTIWlE I..ASERSllWUJNO.
WElft ~ BEOmET.
IIClf1' OEM STRAK. AUSSETZEH.
DANGER
IIMSIII.! LASER RADIATION
WIEH OPEii. AYOIO DIRECT
EXPOSlflE TO BEAM.
2. When replacing parts, use only manufacturer's recommended components for safety. Onside of prcxlucl)
3. Check the condition of the power cord. Replace if wear or damage is evident.
4. After servicing, be sure to restore the lead dress, insulation barriers, insulation papers, shields, etc.
5. Before returning the serviced equipment to the customer, be sure to make the following insulation resistance
test to prevent the customer from being exposed to a shock hazard.
LITHIUM BATTERY &
• CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the manufacture.
Dispose of used batteries according to the manufacture's instruction.
FUSE REPLACEMENT A
• CAUTION
For continued protection against risk
of fire, replace only with same slow
operating type 2A, 250V fuse.