43
VQT2N35
The amount of space left on the SD card can be checked.
(Only when the mode is at the )
≥ Touch [EXIT] or press the MENU button to close the indication.
The amount of space left on the SD card, the built-in memory and HDD can be checked.
(Only when the mode is at the )
≥ Touching [CHANGE MEDIA] switches the unit between the display for the SD card and the
display for the built-in memory/HDD.
≥ Touch [EXIT] or press the MENU button to close the indication.
≥ The SD card, built-in memory or built-in HDD requires some space to store information and
manage system files, so the actual usable space is slightly less than the indicated value.
The usable built-in memory/HDD space is generally calculated as 1 GB=1,000,000,000
bytes. The capacities of this unit, PCs and software are expressed as
1 GB=1,024k1,024k1,024=1,073,741,824 bytes. Therefore, the indicated value of the
capacity appears to be smaller.
Perform the touch screen calibration if a different object to the one touched is selected.
1 Touch [CALIBRATION].
≥ Touch [ENTER].
2Touch the [r] that appears on the screen with the supplied stylus pen.
≥ Touch [i] in sequence (up left # down left # down right # up right # centre).
3 Touch [ENTER].
≥ Calibration cannot be performed when the LCD monitor is turned 180o.
Use this unit to format media.
Formatting built-in memory or HDD is only available with this unit.
Do not format an SD card using any other equipment such as a PC. The card may
not be used on this unit.
[
CARD STATUS
]
/
[MEDIA STATUS]
[CALIBRATION]
To Next Page
Loading...
