Panasonic HomeHawk WINDOW

6
LED indicator Status
Off • No power
• LED indicator is turned off *
1
Yellow lit Not registered to your wireless router (usually for initial setup) or signal level is good *
2
blinking slowly Initial setup is being performed using WPS on your router
Green lit • Registration successfully completed
*
3
• Signal level is strong *
2
blinking slowly Registration mode or updating
blinking quickly Camera is searching for your wireless router
Blue lit Connected to the wireless router and camera is on
Red lit • Registration failed *
3
• Accessing microSD card (when using 24/7 recording)
• Signal level is weak *
2
blinking • Camera is out of range of your wireless router *
2
• Wireless LAN connection failed
• Device error (fan error)*
4
blinking slowly • Streaming data
*
1
or detecting motion *
1
• Accessing microSD card (when not using 24/7 recording)
*1 You can congure the camera so that its LED indicator does not light during normal operation from the
camera settings of the app. For more information‚ access the User’s Guide (page 3).
*2 The signal level (strong‚ good‚ weak‚ out of range) is shown for 3 seconds after pressing
SETUP button.
*3 Lights for 3 seconds after registration is successfully completed or failed.
*4 Unplug the camera and then plug it in again. If the message is still displayed, contact an authorized service
center.