12
INCUBATOR COMPONENTS
LCD touch panel
The following display (called the Top screen) will appear when the power switch is turned ON.
Note: It takes approximately 20 seconds until Top screen is displayed.
2 6 7 8
3
1
1. Present temperature display field
The current chamber temperature is displayed.
2. Set temperature value display field
The set value of chamber temperature is
displayed. Default setting: 37
o
C
3. Heating indicator
This lamp lights when the heater is energized.
4. Present CO
2
density display field
The current chamber CO
2
density is displayed.
Nothing is displayed when CO
2
density is set 0%.
5. Set CO
2
density value display field
The set value of the chamber CO
2
density is
displayed. Default setting: 0 %
6. CO
2
gas injection indicator
This lamp lights when CO
2
gas is being
injected.
7. CO
2
gas supply line indicator A and B*
1
Current supplying CO
2
gas supply line
(connecting port for CO
2
gas pipe) is
displayed. The connecting port A/B for gas
pipe that is currently supplying CO
2
is
displayed in reverse video and blinks.
8. CO
2
gas supply line select key*
1
This is a key to select CO
2
gas supply line A
or B (Connecting port A or B for CO
2
gas
pipe). When an optional gas auto charger
MCO-21-GC-PW is installed, CO
2
gas supply
line A/B changes over automatically when
CO
2
gas cylinder is empty. Changeover is
also workable by pressing this key.
*1: Only when an optional component MCO-21-GC-PW (Gas auto charger) is installed, this key is workable.
They are not displayed when the MCO-21GC-PW is not installed.
5
4
To Next Page
Loading...
