18
INSTALLATION
CAUTION
Do not climb on the incubator or place objects on top of it. Doing so may damage it or cause it to fall
over, resulting in injury.
●In case of double stack
For stacking the incubators surely, refer to the
procedure included with the optional double
stacking bracket KM-CCP17PS2W or the stacking
plate KM-CCP17SB2W.
Note: Two hooks are attached to the rear of the
upper incubator. When stacking incubators, fix the
upper incubator to the wall with these hooks and
wire or chain (See the figure on the point).
Note: When stacking the incubators on our CO
2
incubator or O
2
/CO
2
incubator other than this
product, use the stacking plate KM-CCP17SB2W.
Refer to table 11 on page 89.
When the incubator is not in use
Empty the water from the humidifying pan and remove moisture from the chamber. Make sure that the
chamber is completely dry before closing the doors. Failure to do so may result in damage.
Before moving the incubator
Before moving the incubator, empty the water from the humidifying pan, disconnect the power supply plug
from the outlet, and make sure that the cord will not be damaged. Failure to do so may result in electric
shock or fire.
Hooks
Wire
To Next Page
Loading...
