1.14.4. INSTALLING THE RECORDING PAPER
Letter*, legal** or A4*** size recording paper can be loaded. The unit can hold up to 150 sheets of 75 g/m
2
(20lb.) paper. You may
use 60 g/m
2
to 90 g/m
2
(16 lb. to 24 lb.) paper. Set the recording paper size (code #016 on
PROGRAM MODE TABLE
(P.65))
according to the paper size you use, after connecting the unit.
*Letter=216 mm × 279 mm (8 1/2” × 11”)
**Legal=216 mm × 356 mm (8 1/2" × 14")
***A4=210 mm × 297 mm (8 1/4" × 11 11/16")
To use A4 size paper,
install the A4 paper guides to the paper tray. Refer to
INSTALLING THE PAPER TRAY
(P.14).
For best results, only use inkjet paper such as Hammermill® Jet Print. If you use other types of paper, the print quality may
be affected.
(1) Fan the stack of paper to prevent a paper jam.
(2) Pull the tension bar forward and hold open while inserting
the paper.
· The hight of the stack of the paper should not exceed
the upper limit o the paper tray, otherwise the paper
may jam or multi-feed.
· The paper should not be over the tab.
· If the paper is not inserted correctly, readjust the paper,
or the paper may jam.
Note for recording paper:
·
Avoid paper with a cotton and/or fiber content that is over 20%, such as letterhead paper or paper used for
resumes.
·
Do not use different types or thicknesses of paper at the same time. This may cause a paper jam.
·
Avoid extremely smooth or shiny paper that is highly textured.
·
Avoid paper that is coated, damaged or wrinkled.
Note:
· Avoid double-sided printing
· Do not use paper printed from this unit for double-sided printing with other copiers or printers, or the paper may jam.
· Do not reinsert the ejected paper into the recording paper exit.
· Some paper only accepts print on one side. Try using the other side of paper if you are not happy with the print quality.
Trademarks:
· Hammermill® is a registered trademark of INTERNATIONAL PAPER in the United States and/or other countries.
16
KX-FHD301
To Next Page
Loading...
