Panasonic KX-TDE0101

1 Preparation
Please read the information in this section before upgrading the PBX.
1.1 Safety Notices
Please
observe
the safety notices in this manual in order to avoid danger to users or other people, and prevent
damage to property.
The notices are classified as follows, according to the severity of injury or damage:
WARNING
This notice means that misuse could result in death or serious injury.
CAUTION
This notice means that misuse could result in injury or damage to property.
1.2 Introduction
This leaflet describes the procedures for upgrading a Hybrid IP-PBX (KX-TDA100/KX-TDA200/KX-TDA600
)
to a Pure IP-PBX (KX-TDE100/KX-TDE200/KX-TDE600) by replacing the MPR card.
The following items are necessary for the upgrade:
Model No. Name Description
KX-TDE0101 IP Convergence Main
Processing Card (IPCMPR)
The
main processing card for controlling the Pure
IP-PBX (KX-TDE100/KX-TDE200). This card
comes with an SD Memory Card and 2 ferrite
cores included.
KX-TDE6101 IP Convergence Main
Processing Card (IPCEMPR
)
The
main processing card for controlling the Pure
IP-PBX (KX-TDE600). This card comes with an
SD Memory Card and 2 ferrite cores included.
KX-TDE0110 16-Channel VoIP DSP Card
(DSP16)
Digital signal processor (DSP) cards to be
mounted on the IPCMPR/IPCEMPR card.
Depending on the number and the type of IP
trunks and IP telephones you wish to use, either
the DSP16 or DSP64 card is selected to be
installed.
Note
The
following
activation keys are pre-installed:
• 4-Channel IP Trunk Activation Key: 1 for
DSP16; 4 for DSP64
• 8-Channel IP Proprietary Telephone
Activation Key: 1 for DSP16; 4 for DSP64
KX-TDE0111 64-Channel VoIP DSP Card
(DSP64)
The procedures described in this leaflet use the following files, contained on the SD Memory Cards, and these
files are referred to by their type:
MPR Card Conversion Guide 3
1.2 Introduction