57
KX-TG1034B/KX-TG1035S/KX-TGA101B/KX-TGA101S
11.1.2.2. Batch file Settings
Note:
• “****” varies depending on the country.
11.1.2.3. Commands
See the table below for frequently used commands.
Command name Function Example
rdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data from address
“00 00” to “FF” is read out.
readid Read ID (RFPI) Type “readid”, and the registered ID is read out.
writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the ID “0018 E0 0E
98” is written.
setfreq Adjust Frequency of RFIC Type “setfreq nn”.
hookoff Off-hook mode on Base Type “hookoff”.
hookon On-hook mode on Base Type “hookon”.
getchk Read checksum Type “getchk”.
wreeprom Write the data of EEPROM Type “wreeprom 01 23 45”. “01 23” is address and “45”
is data to be written.
bursttx Burst TX mode Type “bursttx”
testrx Test RX mode Type “testrx”
tph High TX power Type “tph”
tpl Low TX power Type “tpl”
To Next Page
Loading...
