Panasonic KX-TG1381 - Things to Do after Replacing

44
KX-TG1381HKH/KX-TG1381HKV/KX-TG1381HKW/KX-TG1382HKH/KX-TGA131HMH/KX-TGA131HMV/KX-TGA131HMW
11.6. Things to Do after Replacing IC
Cautions:
Since this page is common to each country, it may not apply to some models in your country. The contents below are the mini-
mum adjustments required for operation.
11.6.1. Base Unit
Before doing the following adjustment, be sure to do PC Setting (P.37) in The Setting Method of JIG (Base Unit).
Note:
(*1) Refer to Check Point (Base Unit) (P.28)
(*2) XX: country code, YY: revision number
“XX” and “YY” vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in JIG and PC
(P.37).
11.6.2. Handset
Before doing the following adjustment, be sure to do PC Setting (P.41) in The Setting Method of JIG (Handset).
Note:
(*3) Refer to Check Point (Handset) (P.31)
(*4) XX: country code, YY: revision number
“XX” and “YY” vary depending on the country version. You can find them in the batch file, PQZZ- mentioned in JIG and PC
(P.41).
IC Necessary Adjustment
BBIC Programs for Voice processing, interface for RF and
EEPROM
1. Clock adjustment: Refer to Check Point (E). (*1)
EEPROM Adjustment parameter data
(country version batch file, default batch file, etc.)
1. Default batch file: Execute the command “Default4KB”.
2. Country version batch file: Execute the command
“1311XXvYY”. (*2)
3. Clock adjustment: Refer to Check Point (E). (*1)
IC Necessary Adjustment
BBIC Programs for Voice processing, interface for RF and
EEPROM
1. Clock adjustment: Refer to Check Point (H). (*3)
2. 4.0 V setting and battery low detection: Refer to Check Point
(A), (F) and (G). (*3)
EEPROM Adjustment parameter data
(country version batch file, default batch file, etc.)
1. Default batch file: Execute the command “Default”.
2. Melody Initialize batch file; Execute the Command
“DB3MZA”.
3. Country version batch file: Execute the command
“131XXvYY”. (*4)
4. Clock adjustment: Refer to Check Point (H). (*3)
5. 4.0 V setting and battery low detection: Refer to Check Point
(A), (F) and (G). (*3)