Battery installation/Battery charging
Important:
R Use the supplied rechargeable batteries. For replacement, we recommend using
the Panasonic rechargeable batteries noted on page 2.
R USE ONLY Ni-MH batteries AAA (R03) size (A).
R Do NOT use Alkaline/Manganese/Ni-Cd batteries.
R Confirm correct polarities (
, ).
Charge for about 7 hours.
R Confirm “Charging” is displayed (B).
R When the batteries are fully charged, “Fully charged” is displayed.
Note:
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
, ) and the charge contacts with a dry cloth and
charge again.
Registering a handset to a base unit
1 Base unit:
Press and hold MLOCATORN for about 5 seconds.
R Depending on the base unit, a registration tone sounds.
R If all registered handsets start ringing, press MLOCATORN again to stop,
then repeat this step.
2 Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and
is displayed.
Note:
R If an error tone sounds, or if
is displayed, register the handset according to
the base unit’s operating instructions.
For assistance, please visit http://www.panasonic.com/help
3
Installation
To Next Page
Loading...
