R Model shown is KX-TGHA20.
Note:
R The handset display may show “Please wait for 1 minute.” when the
handset is placed on the charger if it is not registered to the base unit.
R If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
, ) and the charge contacts with a dry cloth and
charge again.
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold M
N for few
seconds to turn the handset on.
1 Handset:
Lift the handset and press M
N.
2 Base unit:
Press and hold MLOCATORN for about 5 seconds.
R If all registered handsets start ringing, press MLOCATORN again to stop,
then repeat this step.
3 Handset:
Place the handset on the base unit or charger.
R Continue the operation even when the handset display shows “Please
wait for 1 minute.”.
4 With the handset still on the base unit or charger, wait until a confirmation tone
sounds and
is displayed.
Note:
R If an error tone sounds, or if
is displayed, register the handset according to
the base unit’s operating instructions.
4
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
Installation
To Next Page
Loading...
