test its sensitivity. Check the connection if you
a
re diverting the baby monitor to an outside line.
R This feature should not be used as a substitute
for a medical or caregiver’s supervision. It is the
caregiver’s responsibility to stay close enough
to handle any eventuality.
Note:
R If the unit is connected to a PBX system, you
cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset on
charger.
R The monitored handset never rings while it is
being monitored. If the base unit is placed near
the monitored handset, we recommend turning
off the base unit ringer volume (page 30).
Setting the baby monitor
Perform the setting operation with the handset to
be monitored (for example, the handset placed in
a baby’s room).
To monitor with a unit
T
he internal baby monitor feature is available:
– between handsets
– between a handset and the base unit
Handset
1 MM
ENUN#268
2 MbN: “On” a MSELECTN
3 MbN: Select the desired unit’s number to
monitor with. a MSAVEN
R “Baby monitor” will be displayed.
R The registered unit’s name/number is
displayed.
Note:
R When this feature is on, another handset or the
base unit can hear the monitored handset by
making an intercom call.
To monitor from an outside line
I
f you enable this feature, the unit will call a
pre-programmed phone number when the handset
detects sound. After you answer the call, you can
listen in on the room where the handset is located.
Handset
n F
rom the phonebook:
1 MMENUN#268
2 MbN: “On” a MSELECTN
3 MbN: Select “Outgoing call” to monitor
from an outside line. a MEDITN a MADDN
4 MbN: “Phonebook” a MSELECTN
5 MbN: Select the phonebook entry. a MSAVEN
R “Baby monitor” will be displayed.
Note:
R If you edit a phonebook entry which is assigned
for monitoring, the edited entry does not transfer
to the monitor.
n By entering phone numbers:
1 MMENUN#268
2 MbN: “On” a MSELECTN
3 MbN: Select “Outgoing call” to monitor
from an outside line. a MEDITN a MADDN
4 MbN: “Manual” a MSELECTN
5 Enter the desired name. a MOKN
6 Enter the desired number. a MOKN a
MSELECTN
R “Baby monitor” will be displayed.
Note:
R The registered name/number is displayed.
Turning off the baby monitor
T
he monitored handset cannot be used while baby
monitor is set to “On”.
Handset
1 P
ress MMENUN on the handset being
monitored.
2 MbN: “On/Off” a MSELECTN
3 MbN: “Off” a MSELECTN a MOFFN
Editing an outside monitoring number
Handset
1 P
ress MMENUN on the handset being
monitored.
2 MbN: “On/Off” a MSELECTN
3 MbN: “On” a MSELECTN
4 MbN: Select the outside line. a MEDITN
For assistance, please visit http://shop.panasonic.com/support
35
Programming
To Next Page
Loading...
